When you start your system, slowly tap the F12 key until you see the message 'Entering the one time boot configuration' in the upper right corner of the screen. Use the arrow keys to select the 'Device Configuration' option, then press the Enter key. This opens the system setup UEFI configuration options for your LSI MegaRAID RAID controller. Note: For this example, two SATA 10tb drives were used to create a RAID 0. The menu to configure the RAID array is hidden.You only see RAID options that are on par for the amount of drives you have installed.

Use the left arrow and click one time to reach the following menu (you can also use the right arrow, but it requires more clicks to reach the same menu). The 'Create Virtual Drive' option is already highlighted.Then use the up/down arrow and select the menu option 'Configure.' Press the Enter key to continue. RAID 0 is selected by default and is what this example describes. Press the Enter key to select a different RAID type as needed. Press the Enter key again to return to this menu. Add the physical drives for the RAID array. Use the up/down arrow and select 'Enabled'.Press the Enter key and a pop-up menu shows up.Use the up/down arrow and select the first drive.The next operation is a multi-step action.Use the up/down arrow and highlight the menu 'Select Drives'.

Bruno furst memory course pdf